Microflex Wireless Wireless Microphone Systems
0- Category:SHURE
Microflex Wireless Specifications
System
RF Carrier Frequency Range
| Band | Region | Frequency Range |
|---|---|---|
| Z10 | USA , Canada , Mexico | 1920– 1930 MHz |
| Z11 | Europe , Asia , Middle-East | 1880– 1900 MHz |
| Z12 | Japan | 1893– 1906 MHz |
| Z15 | Taiwan | 1880– 1895 MHz |
| Z14 | Brazil | 1910– 1920 MHz |
Audio Frequency Response
65 Hz – 16 kHz
Power Consumption
2.5 W
Maximum Output Power
3.0 W RMS
Preamplifier Output Clipping Level
<1% THD
Signal-to-Noise Ratio
<90 dB A-weighted
Cable Requirements
Cat 5e or higher
Dimensions
61 x 150 x 168 mm
Weight
650 g
Operating Temperature Range
5℃ (41℉) – 40℃ (104℉)
Transmitters
Gain Adjustment Range
−25 to +15 dB (in 1 dB steps)
Maximum Input Level
Mic gain @ −16 dB
−9 dBV
Headphone Output
3.5 mm (1/8″), dual mono (will drive stereo phones)
Maximum Headphone Output Power
1kHz @ 1% distortion, peak power, @16Ω
17.5 mW
Antenna Type
Internal, Spatial Diversity, Linear Polarization
Antenna Gain
| Average | -1.1 dBi |
| Peak | 0.5 dBi |
Charge Connector
USB 3.0 Type A
Housing
Molded Plastic
Recommended Storage Temperature Range
0°C (32°F) to 25°C (77°F)
MXW1 Hybrid Bodypack Transmitter
Microphone Connector
4-Pin male mini connector (TA4M), See drawing for details
Input Impedance
@ 1 kHz
>20 kΩ
Internal Microphone
Omnidirectional (20 Hz – 20 kHz)
Battery Life
| Standard Density Mode | High Density Mode |
|---|---|
| Up to 7 hours | Up to 8 hours |
Calculated with a new battery. Runtimes vary depending on battery health.
Dimensions
22 mm x 45 mm x 99 mm (0.9 in. x 1.8 in. x 3.9 in.) H x W x D
Weight
85 g (3.0 oz.)
with batteries, without microphone
MXW2 Handheld Transmitter
Microphone Capsule
SM58, SM86, Beta58, VP68
Configuration
Unbalanced
Input Impedance
@ 1 kHz
>20 kΩ
Battery Life
| SB902, Standard Density Mode | SB902, High Density Mode | SB905, Standard Density Mode | SB905, High Density Mode |
|---|---|---|---|
| Up to 15 hours | Up to 16 hours | Up to 23 hours | Up to 29 hours |
Calculated with a new battery. Runtimes vary depending on battery health.
Dimensions
226 mm x 51 mm (8.9 in. x 2.0 in.) L x Dia.
including SM58 microphone capsule
Weight
369 g (13 oz.)
with batteries, including SM58 microphone capsule
MXW6 Boundary Transmitter
Microphone Capsule
| MXW6/O | R183B |
| MXW6/C | R185B |
Battery Life
| Standard Density Mode | High Density Mode |
|---|---|
| Up to 7 hours | Up to 8 hours |
Calculated with a new battery. Runtimes vary depending on battery health.
Dimensions
23 mm x 44 mm x 114 mm (0.9 in. x 1.75 in. x 4.5 in.) H x W x D
Weight
108 g (3.8 oz.)
with batteries
MXW8 Gooseneck-Base Transmitter
Microphone Connector
6-pin connector for Shure MX405/10/15
Configuration
Unbalanced
Input Impedance
@ 1 kHz
>20 kΩ
Gooseneck Options
See accessories list
Battery Life
| Standard Density Mode | High Density Mode |
|---|---|
| Up to 7 hours | Up to 8 hours |
Calculated with a new battery. Runtimes vary depending on battery health.
Dimensions
36 mm x 71 mm x 124 mm (1.4 in. x 2.8 in. x 4.9 in.) H x W x D
Weight
193 g (6.8 oz.)
with batteries, without microphone
Access Point Transceiver (APT)
Network Interface
RJ45: Gigabit Ethernet, Dante digital audio
Plenum Rating
UL 2043
Power Requirement
Power over Ethernet (PoE) Class 0, 6.5W
Antenna Type
Internal, Spatial Diversity, Circular Polarization
Antenna Gain
| Average | 0.5 dBi |
| Peak | 3.0 dBi |
Housing
Molded Plastic, Cast Zinc
Dimensions
24 mm x 170 mm x 170 mm (1.35 in. x 6.7 in. x 6.7 in.), H x W x D
Without mounting plate or cover
Weight
| APT8 | 856 g (1.9 lbs) |
| APT2, APT4 | 845 g (1.9 lbs) |
| Paintable Cover | 85 g (0.2 lbs) |
| Mounting Bracket | 68 g (0.15 lbs) |
Networked Charging Station (NCS)
Charge Time
| MXW1, MXW6, MXW8 | 50%=1 hour; 100%=2 hours; High Efficiency Mode=4-5 hours | |
| MXW2 | SB902 | 50%=1.5 hour; 100%=3 hours; High Efficiency Mode=4-5 hours |
| SB905 | 50%=2.5 hour; 100%=5 hours; High Efficiency Mode=5-6 hours | |
Network Interface
10/100 Mbps Ethernet
Power Requirement
15 V DC @ 3.33 A maximum, supplied by external power supply (tip positive)
Housing
Molded Plastic, Cast Zinc
Dimensions
| NCS8 | 68 mm x 343 mm x 184 mm (2.7 in. x 13.5 in. x 7.25 in.), H x W x D |
| NCS4 | 68 mm x 191 mm x 184 mm (2.7 in. x 7.5 in. x 7.25 in.), H x W x D |
| NCS2 | 48 mm x 102 mm x 154 mm (1.9 in. x 4.0 in. x 6.1 in.), H x W x D |
Weight
| NCS8 | 2.9 kg (6.4 lbs) |
| NCS4 | 1.7 kg (3.7 lbs) |
| NCS2 | 0.8 kg (1.8 lbs) |
Audio Network Interface (ANI)
Audio Network Interface (ANI)
Audio Frequency Response
20 Hz to 20 kHz (+1, −1.5 dB)
Dynamic Range
20 Hz to 20 kHz, A-weighted, typical
| Analog-to-Dante | 113 dB |
| Dante-to-Analog | 110 dB |
Output Noise
20 Hz to 20 kHz, A-Weighted, typical
| Line | Aux | Mic |
|---|---|---|
| −84.5 dBV | −95.2 dBV | −106.5 dBV |
THD+N
20 Hz to 20 kHz+4dBu analog input, −10 dBFS digital input
<0.05%
Polarity
Non-inverting, any input to any output
Dimensions
44 mm x 483 mm x 366 mm (1.7 in. x 19.0 in. x 14.4 in.), H x W x D
Weight
| MXWANI4 | 3.1 kg (6.9 lbs) |
| MXWANI8 | 3.2 kg (7.1 lbs) |
Housing
Steel; Extruded aluminum
Power Requirements
100 to 240 V AC, 50-60 Hz, 1 A
Operating Temperature Range
−18°C (0°F) to 63°C (145°F)
Storage Temperature Range
−29°C (-20°F) to 74°C (165°F)
Analog Connections
Outputs
| Configuration | Impedance | Clipping Level (minimum) | ||
|---|---|---|---|---|
| Line | Aux | Mic | ||
| Active Balanced | 310 Ω | +26.2 dBV | +16.2 dBV | −3.8 dBV |
Input(s)
| Configuration | Impedance | Clipping Level (minimum) | |
|---|---|---|---|
| Line | Aux | ||
| Active Balanced | 10.6 kΩ | +23.8 dBV | +10.8 dBV |
Headphone Output
6.35 mm (1/4″) TRS, 100 mW, 350 Ω, dual mono (will drive stereo phones)
0 dBV = 1 V RMS; 0 dBu = 0.775 V RMS; 0 dBV = 2.2 dBu
Digital Signal Processing
AD/DA Converter
24-bit, 48 kHz
Latency
Estimated Nominal, ±0.1 ms
| Analog-to-Dante | 0.21 ms |
| Dante-to-Analog | 0.24 ms + TN |
TN = Network latency in milliseconds, as set in Dante Controller.
Note: Dante network latency is typically associated with the receiving device.
Networking
Network Interface
Four-Port Gigabit Ethernet Switch, Dante digital audio
Uplink Port (Port 4)
Selectable, blocks multicast traffic
Power over Ethernet (PoE)
Provided on Port 1 to power MXWAPT
Cable Requirements
Cat 5e or higher, shielded, 100 m maximum between network devices
Network Addressing Capability
DHCP, link-local, static
Transmitter Output Power
Bands: Z10, Z11, Z14, Z15
MXW1
| Setting | dBm | mW |
| Low | -2 | 1 |
| Medium | 5 | 3 |
| High | 12 | 16 |
| Maximum | 17 | 50 |
MXW2
| Setting | dBm | mW |
| Low | 0 | 1 |
| Medium | 7 | 5 |
| High | 12 | 16 |
| Maximum | 17 | 50 |
MXW6, MXW8
| Setting | dBm | mW |
| Low | -2 | 1 |
| Medium | 5 | 3 |
| High | 12 | 16 |
| Maximum | 19 | 80 |
Band: Z12
MXW1, MXW6, MXW8
| Setting | dBm | mW |
| Low | 0 | 1 |
| Medium | 5 | 3 |
| High | 9 | 8 |
| Maximum | 12 | 16 |
MXW2
| Setting | dBm | mW |
| Low | 0 | 1 |
| Medium | 7 | 5 |
| High | 9 | 8 |
| Maximum | 12 | 16 |
Wiring Diagram
TA4M Connector
Audio Network Interface (ANI)
Reviews
There are no reviews yet.